GuideReparing our Food Blender — a Full Guide Replacing the motor for repairing your food blender is one of these tasks you may want to tackle yourself. Knowing the common problems and fixes can save you time and money. This article provide you a comprehensive guide on how to repair food blender efficiently.
Most Common Blender Problems and How to Fix Them
Multispeed Switch Servicing
It is the frequent use of this switch point that leads to so many problems surfacing with it. To repair it:
The switch is under the Easy Pour base, so remove that to get close enough.
Check for loose or broken terminals
Test this with a continuity tester. Blow out with compressed air or replace if defective.
Replacing the Fuse
Blown Fuse: The blender will not work if a fuse is blown. To check and replace:
Find the fuse in the wiring that stands between the multispeed switch and motor
Blown: Test it with a continuity tester
If necessary, replace it with a new fuse of the same rating.
Servicing the Motor
Engines can be good for many year but if they do not function then you need to repair them. To test:
To conduct the test with an ohmmeter, connect cables prong by probe on each of its terminals.
If resistance changes while turning speed controls, malfunction may likely be the cause.
Tightening the Drive Stud
Loose Drive Stud: If the blades are not spinning as they should, this is often due to a loose drive stud
Hold the drive stud and twist it in clockwise direction while you are holding the end of pivoting motor shaft upside down.
Replace if worn using the disassembly instructions.
Servicing the Blade Assembly
A leaking in the assembly may occur, or it simply fails to blend:
Tighten any loose components.
Inspect face seal for contamination or wear, replace as needed.
Conclusion
Most small appliance repairs are relatively simple, requiring only a few basic tools and some knowledge of the components involved. Users may also significantly prolong the lifespan of their appliances by troubleshooting common issues such as switch malfunctions, blown holder fuses, motor problems including chain-stops and burned-out rotors; loose drive studs or blade assembly faults.blender repair (ad)
