Read More : Steps for Fixing the Preparing Automatic Repair Loop in Windows 10 Ways to fix ‘Preparing Automatic Repair’ loop– Facing “preparing automatic repair” loop can be frustrating but there are few useful methods by which you can sort this issue possible. We have everything from simple software troubleshooting to advanced critical repair methods listed in separate sections to get Windows 10 device back to work properly.
Perform a Hard Reboot
Rendom reboots usually solve boot proplems due to some temp. bug only chronicles reset memories permanently, ONLY! To perform this:
Hold down the power button until your computer does not completely shut off.
After some seconds, turn it ON again.
Normally that simple step can reset your computer, and then you may have a working Windows machine.
Boot into Safe Mode
If the hard reboot is unsuccesful, try to go on safe mode :
Reboot your PC and power off three times during the boot process.
The fourth restart should take you to the Recovery Mode in Windows.
Go to Troubleshoot >
Advanced options > Startup Settings and then click on Restart.
When the Boot menu appears, select 4] Enable Safe Mode, and press ENTER.
The Safe Mode only loads the basic drivers, it might be able to bypass that problem.
Disable Automatic Repair
If you are stuck at the automatic repair loop, You may need to disable this certain feature.
Enter the Command Prompt from Recovery Mode (the same way as entering Safe Mode).
Then run bcdedit /set {current} recoveryenabled no and hit Enter again.
Turn off automatic repair: This will save you from getting stuck in repair loops12.
Refresh or Reset Your PC
How to refresh or reset your PC If all else fails, you can even try refreshing or resetting your computer.Windows Repair (ad)
In the Recovery Mode, open Troubleshoot > Reset this PC and Then.
Either Keep my files or Remove everything
That way you get a new version of Windows without losing all your personal files.
Perform a Clean Install or Reinstall the Windows 10
In the worst case scenario where all your previous attempts to fix this issue have failed, you might have to resort to a clean Install of Windows 10:
Make a bootable USB using other PC
Reboot your machine and boot into the USB drive, follow the prompts of installation.
Remember that this will wipe everything on your system, so do not forget to backup all the important stuff.
With these steps now completed, this should fix the “Preparing Automatic Repair” loop in Windows 10 and you should be able to use the OS as if nothing happened.
