A Complete Guide to Repairing Drywall After Electrical Work: (for Small Holes)Repairing drywall after electrical work can be quite a challenge, but there are many ways to do it well and quickly; A guide on the best techniques for a smooth finish. We will analyze in more detail the process of:
How The Repairs Work
Preparation:
Floor should be safely prepared. It is also important to turn off power from any electrical circuits near where you are working as leaving it on could be dangerous.
Find all required items: 120 grit paper, a spackling knife for the drywall compound, potentially a patch depending on the size of the hole.
Sanding the Area:
Smooth the edges of the hole with 120-grit sandpaper. It is very important that you do coat each item, as it makes for a much better bond (will stick better) and you will have less of a ridge to feather-wet-sand.
Applying Drywall Compound:
Use a putty knife to press drywall compound into the hole. While slightly overfilling ensures that you have enough to sand later.
Drying Time:
Leave the compound to dry, this can take 2-3 hours. This is absolutely necessary to get a good repair.
Final Sanding:
After its dry, sand the repair flat with 120-grit sandpaper again. This will insure a even transition from the repair to the existing wall.
Additional Tips for Success
Use A Patch: If there is drywall damage such as larger holes or structural integrity is an issue, then you likely want to use a self-adhesive mesh patch before applying compound.
Texture Matching: If your wall had a texture buy a can of spray texture or if you want to get really ambitious you could use this plastic crows foot brush.
You can paint over the repaired area by sanding to make the surface dust-free and painting in order to match your wall.drywall repair (ad)
Common Mistakes to Avoid
Not allowing to Dry: Not giving it sufficient time to dry can cause cracks in the repair.
Poor Sanding: If you do not sand well, you will see the imperfections on your wall
Do Not Ignore Precautions>
Always make sure that electric power is turned off in areas where you work.
If you follow these steps and be careful to follow the tips, you can repair small holes in drywall after electrical work that look as if they were never there.
